#UNABLE TO FIND ALESIS IO26 PRO#

That would all get subsequently downmixed and spat out into the headphone ouput.Д«ut that's where i hit a bit of a snag - the 'Phones 1' output is hard-wired to mirror the analog outputs 1/2, while 'Phones 2' can be selected to mirror either of the four pairs of analog outs. 8 channels of audio) to the 8 analog outputs, and then run wires from said analog outputs (inside the unit) to the line inputs, to allow for gain adjustment for each channel. I was hoping to be able to route the signals from one ADAT input (ie.

without being connected to a computer), as a crude mono 'monitor mixer' of sorts. The main idea was to be able to use the unit stand-alone (ie. Unfortunately, the io|26 was ever so slightly 'gimped' in this area.

#UNABLE TO FIND ALESIS IO26 PRO#

In previous Dice II-based interfaces i've owned ( Focusrite Saffire Pro 40) or, respectively, still own (the aforementioned TC Electronics StudioKonnekt 48), one can route almost any input signal to any output. I mean, see for yourselves.ДЄnd now we come to the part of the project that gets really interesting. That being said, the control GUI looks oh-so-very-90's-ish. The 'transplant' succeeded uneventfully, and after installing the drivers, as expected (or at least hoped), the thing works just fine. On the bright side though, that was a bit of a non-issue, in fact - since the Konnekt 8 i had scavenged the Dice II chip from, as described in an earlier blog post here, i figured i wouldn't be needing the services of the TSB41AB2 (which i knew to be good) that was on that particular board, so. Sadly, i had run out of brand new ones (although there's a few in my Mouser shopping cart with my name on'em). Instead of the entire all-encompassing board.ДЇirst step was, obviously, swapping out the Firewire interface chip. Overall yield that badly - you only need to replace a smaller sub-board, Less costly (you can fit more copies onto the same panel), and ifДЄnything goes wrong during assembly or whatever, it won't affect the Signals from the Dice II chip (200-some-odd balls), but the rest of the circuitry can do FairД®nough, i suppose - you need at least four layers to fan out all the The unit's made up of several smaller circuit boards. The sort of 'added bonus', one might say, were the gain adjustments for the 8 analog (mic/line) inputs.Д«efore we 'get into the meat of'er' (sorry, just can't shake AvE's influence.), how's about a bit of a going-over, hmm? Yes? I thought you'd agree. First, because i knew it was based on the TC Applied Technologies Dice II chip, and as such, should have flexible enough mixing / routing options second, due to the ADAT inputs available.

Unable to find alesis io26